Atlas Mavros Ultra RCA

New product

  • Highest quality ‘6N’ (99.99997% purity) copper
  • Continuous copper/Mylar™ electrostatic screen with copper shielding braid
  • Microporous PTFE (Teflon™) tape
  • Protective FPE (Flexible PolyEthylene) dielectric
  • Low mass, high bandwidth, cold-weld Ultra RCA connectors

More details

By buying this product you can collect up to 3960 loyalty points. Your cart will total 3960 loyalty points that can be converted into a voucher of S$ 198.00.


S$ 2,080.00

Add to wishlist

Data sheet

Capacitance (pF/m) :48.92 pF/m
Connector :Ultra RCA
Construction :Twin multicore dual drain
Conductor Material :OCC
Dielectric :Microporous PTFE (Teflon™)
Outer Diameter :9.8mm
Resistance (Ohms/m) :0.0181
Inductance (µH/m) :0.7256 µH/m
Velocity of propagation :0.81
Screening :Braid + Mylar™, 100%
WarrantyLimited 5 Years

More info

The Mavros Ultra RCA is a high speed wide-bandwidth interconnect designed to complement the performance of ‘high-end’ audio systems by achieving maximum signal transfer.

The Mavros Ultra RCA uses the very highest quality ‘6N’ (99.99997% purity) copper manufactured using the OCC ‘Ohno Continuous Cast’ technique. Cables manufactured with lower grade materials and poor manufacture typically have a coarse, grainy structure which compromises sound quality. In the manufacture of Mavros, Atlas maximise the copper’s conductivity by ensuring that there is typically one grain in approximately 125 metres of conductor, allowing the signal a continuous unbroken path – in practice, the signal has a faster, cleaner and more direct path to follow.

The cable consists of a pair of conductors, each made up from six bundles of 12 multi-conductor wires, plus a thicker centre wire. This in turn is covered by a continuous copper/Mylar™ electrostatic screen with copper shielding braid, ensuring minimal susceptibility to RF interference and noise.

Theoretically, the best dielectric (insulation layer) is air. Conventional dielectric (insulation) materials impose their own signature distortion and loss on the signal. Atlas technique uses a microporous PTFE (Teflon™) tape, which is wound around the core conductors, then covered again and stabilised using a protective FPE (Flexible PolyEthylene) dielectric. This process maintains the required conductor geometry, and bestows greater manufacturing consistency. Termination is with Atlas low mass, high bandwidth, cold-weld Ultra RCA connectors, which have minimal effect on the integrity of the signal.



Reviews

Write a review

Atlas Mavros Ultra RCA

Atlas Mavros Ultra RCA

  • Highest quality ‘6N’ (99.99997% purity) copper
  • Continuous copper/Mylar™ electrostatic screen with copper shielding braid
  • Microporous PTFE (Teflon™) tape
  • Protective FPE (Flexible PolyEthylene) dielectric
  • Low mass, high bandwidth, cold-weld Ultra RCA connectors

30 other products in the same category: